Galvanizing lines for wire
GalvaGREEN, Ecological Annealing And Hot-Dip Galvanizing Lines For Wires
- No ACID HCL
- FLUX is not used
- Energy saving due to higher efficiency of the furnace(s).
- Speed up DV400
- Intermediate stock of raw material 3 times smaller.
- ZINC ALUMINIUM IN A SINGLE BATH.
- 75% less zinc dross
- Complete lines up to 20 wires (2.300 Ton/month)
- Energy saving due to higher efficiency of the furnace(s). (up to 75%)
- Solutions from 1 wire (130 Ton/month) expandable to 10 wires (1.300 Ton/month).
- Very low «stand-by» energy consumption if the line is not producing (i.e. over weekends).
- The line can be transferred to another site in a very short time.
- Smaller zinc kettle (more than 90% reduction in zinc investment, 10 Ton (20.000€) vs 120 Ton (240.000€) In traditional Process).
- Plant space saving because of smaller footprint – 80 mts. GALVAGREEN vs 140 mts. traditional galvanization technology.
The line can be easily and efficiently stopped and started in a very short time, because of very low thermal inertia (the line is ready to run from «stand-by» mode in minutes); gas furnaces take days to reach operation temperature).
- Very low «stand-by» energy consumption if the line is not producing (i.e. over weekends).
- Technology designed from scratch to the most modern standard: less and easier maintenance, higher ergonomics, safer operation.
- Much higher quality of the annealing: exactly the required power to anneal the wire is applied to guarantee maximum quality, highest speed and lowest energy consumption.
- Independent thermal process parameters for each wire strand increase quality and reduce energy consumption.
- Higher operator productivity. (2-3 operators per turn plus a line supervisor, 19 people per month in GalvaGREEN vs 4-5 operators per turn plus line supervisor, 25 people in a traditional galvanizing line).
- Higher operator productivity. (150 Tons/month/operator GALVAGREEN vs 75 Tons old galvanizing technology)
- Lower conversion cost.
- ACID neutralization installation is not necessary.
- Lower installation cost. (80% less civil works), fast installation, less zinc stocked)
%
Less production cost
%
Less of space.
%
Less cost implementation
%
Less Dross Zinc.
%